RUTEC VARDAFLEX Select Supra Kurzanleitung Seite 2

G
Select Supra
The LED strip is only suitable for installation in dry
indoor rooms.
Risk of electric shock!
Be sure to have a professional electrician complete
in stallation. There is no warranty coverage for any lights
installed without observing european safety directives.
Caution!
Only connect the LED strip to a suitable
power supply (24 V DC).
Only operate when completely unrolled.
Connect LED strips in parallel.
Scope of delivery
1 x 2.94 metre LED strip
Technical data
Power supply 24 V power supply with constant
output voltage
Power 147 W
Current strength 6.125 A
Beam angle 120°
Quantity LED 370
Length maximum 2.94 metres per connection
Dimensions 2940 x 12 x 1.7 mm
Bending diameter 60 mm
Compliant with the applicable
european CE directives
Safety class 3 - low voltage protection
Profile necessary
The
additional cooling element and
sufficing air ventilation.
Suitable for indoor use only
Please refer to the respective article on www.rutec.de for
complete technical data!
Installation
Risk of electric shock!
Switch off voltage prior to installation. Ensure that voltage
cannot be accidentally switched on again.
First connect the
to the power supply (not included in the scope of delivery).
Caution!
On conducting surfaces, place an insulation layer between the
of dust, grease and dry.
1. Prepare surface.
2. Shorten
3. Peel off adhesive film and gently press on
LED strip, do not press directly on the LEDs.
4. Connect
Shortening the LED strip
Risk of electric shock!
Always disconnect the mains plug before shortening.
14 LEDs (105 mm) (Fig. 1).
Separate the
For a tightly assembled LED strip is a micro side cutter or an
optional cutter required.
Caution!
With soldered connections note that the soldering
tem perature is 260° C and the soldering duration a
maximum of 10 seconds per soldering point.
LED strip needs an
Only use neutral cross-linked silicon (never use silicon which
includes vinegar!).
Disposal
Dispose of electrical and electronic equipment in an
environmentally friendly manner. Please contact your local
council for further information.
LED strip to a controller and then
LED strip and surface. Surfaces must be flat, free
LED strip if necessary (Fig. 1).
LED strip to power supply.
LED strip can be separated in each case after
example figure
Figure 1
LED strip at the marked position.
Carl-Zeiss-Str. 15
28857 Syke
G