Cleaning Instructions - Konsta 5648260 Aufbauanleitung

8063020 / 7800499 / 5648260 / 8644817 / 8644816 / 8644814
Important information
Please check the construction set for completeness using the position list in good time before starting
construction or commissioning your construction team.
If individual parts are defective or missing, we will deliver these as quickly as possible. However, we cannot refund the
costs for any resulting construction delays to a construction company.
Please understand that we cannot assume any guarantee for the following defects:
- incorrect storage before assembly
- incorrect anchoring with the ground or inadequate foundation
- incorrect anchoring to the house wall
- damage through a higher level of snow burden than statically envisaged.
- Recommendation: lad relief of the roof by removing the snow layer
- storm damage (insurance cases) or violent destruction
- damage through any alteration to the design by the client
- natural formation of cracks, branch holes, twisting, decolouration or similar modification
(natural process; has no influence on the statics)
Storage information until construction:
- store material on a level and dry surface!
- protect against sunshine and dampness!
- to avoid deformation caused by heat due to stacked plastic plates, it is important to keep it away from sun and
heat.

Cleaning instructions:

Please observe the attached information sheet "Care instructions/Colour treatment".
General tips and advice:
- Foundation suitable for structure (not supplied):
Concrete C25/30, reinforcing steel 500 (M), concrete cover 5cm, each 3 ∅ 12 crosswise under the support,
-
The carports are designed for assembly on post anchors (included in the scope of delivery!)
- Attachment material used on site must comply with the static requirements of your carport.
-
The roof sheets must not be placed close to the soffits. Leave a small clearance of approx. 1cm.
-
They must be predrilled by 8mm before attachment. Position the screws (Ø 4mm) centrally in the predrilled
hole (Ø 8mm). The screws must only be lightly tightened so that they do not form a "screw-in cone". The rubber
seal must only rest lightly on the plate.
-
The roof is not designed for walking on.
- If walls are added, there must be a distance of at least 20 cm between roof and wall top for air circulation, as
otherwise heat build-up can occur under the roof panels. The same applies to parked vehicles or objects.
- The carport shall not be mounted onto walls, make sure there is plenty of air circulation of at least 50 cm
distance between the roof edge and wall. (Heat build-up causes deformation of the roof panels as a result of
overexpansion.)
- Do not bond roof panels with silicone.
Please note that we cannot accept any liability for structural changes.
Technische Änderungen vorbehalten. Stand 01/15