Wintec SMART Gebrauchsanweisung Seite 24

HOW TO USE THE BAND
How to remove the stimulator from the belt
Shut off the stimulator.
Take out the stimulator from the belt by pushing out the top.
When the unit is disconnected from the magnetic contact lift it upwards.
Battery replacement
Shut off the stimulator. Remove the battery cover by sliding it downwards and
take out the batteries. Placed 3 alkaline batteries of 1,5V AAA type LR03 and
close the cover. Make sure that the new batteries are correctly placed with
respect to the polarity (note marks for + and-)
Don't throw the battery or electrodes out but recycle or get rid of them appro-
priately following the removal rules in force in your country.
How to put on the BAND
The Band has been created to be adapted to a large number of different sizes.
The special material allows an optimal contact to the skin that guarantees an
efficacious and comfortable stimulation.
Dampen the electrode and the skin uniformly with water or gel and place the
side with the black electrodes directly on the skin.
It is advisable to tighten the band so that to assure a perfect contact with the
skin and muscle.
How to place the stimulator in the Band
Shut off the stimulator. To place the stimulator in the band, simply insert it in
the apposite compartment with the display upwards. A "click" warns you that
the unit is well linked.
It is forbidden the reproduction and the copy of this manual without written permission of producer. REV. ING. 10_10 Data di emissione 10_10_2010
24