Werbung
Verfügbare Sprachen
Verfügbare Sprachen
S a f e t y R u l e s
This instruction sheet must be read with particular attention to the safety rules listed in the TX2000 instruction manual
07900-00759 and to the following safety rules, by any person operating the battery checking device or handling the
batteries.
1
Do not use the battery-checking device outside the design intent.
2
Do not use batteries with this device other than those that are recommended and supplied by Avdel UK Limited.
3
The battery-checking device must be maintained in a safe working condition at all times.
4
The battery-checking device must at all times be operated in accordance with the relevant health and safety legislation. Any
question regarding the correct operation of the device and operator safety should be directed to your local Avdel UK Limited
company or authorised representative.
5
Ensure that vent holes do not become blocked or covered.
6
Do not operate the device in an environment allowing exposure to moisture, rain, combustible fluids or gasses.
7
Regularly check the battery-checking device and in case of damage have repairs completed by an authorised Avdel representative.
8
Do not discard batteries into water or fire, (danger of explosion). The battery must be disposed of in accordance with
environmental regulations.
F e a t u r e s
Device for analysing the charge capacity, temperature and condition of Avdel® 12V Ni-Cd and Ni-MH Battery Packs.
•
Battery Capacity Level
•
A coloured LED scale on the top of the unit indicates the level of charge remaining in terms of a percentage and a voltage
value.
•
The battery capacity level can also be monitored in a loaded condition.
•
Battery Voltage
•
Green LED indicates whether the battery voltage is greater than 10V, less than 10V or less than 3V.
•
If the green LED indicates that the battery voltage is less then 3V this is a good indication that the battery has reached the
end of its life or is defective.
•
Battery Temperature
•
Red LED indicates whether the battery is at the optimum temperature for charging, is too hot or cold for charging or
defective.
•
Battery Condition
•
If either the green or red LED do not emit a signal this is a good indication that the battery has reached the end of its life or is
defective and therefore requires replacing.
B e n e f i t s
•
Enables the user to determine the remaining charge level of the battery in both an unloaded and loaded state and therefore
determine whether the battery requires re-charging prior to use.
•
Enables the user to optimise the life of the battery by charging from the correct level. The optimum battery cycle life is achieved
when the battery is re-charged from a capacity greater than 10% and less than 60%.
•
Enables the user to charge the battery at the correct temperature. Leaving the battery within the checking device will also cool the
battery to the correct temperature within 5 to 10 minutes.
•
Enables the user to identify batteries that are at the end of their life cycle or defective, requiring replacement.
Werbung
