LG ESS HB 7.0 Installationsanleitung Seite 55

3.1.6 Mounting bracket
When installing the battery pack on a wall, make sure that the wall is capable of supporting the
weight of the battery pack.
To mount the battery pack on a wall, take the following steps :
A Mark the location on the wall for the holes.
B Drill holes for fasteners in the wall.
C Drive the fasteners through the mounting bracket into the holes.
Area 1
Area 3
At least 250mm
Ex)
CAUTION
y Make sure that the battery pack is at all times exposed to the ambient air.
The battery pack is cooled by natural convection. If the battery pack is entirely or partially
covered or shielded, it may cause the battery pack to stop operating.
y Recommended diameter :
Area 2
10mm(0.4") Min.
y Recommended length :
70mm(2.8") Min.
y Recommended material :
Stainless steel (8.8T)
y Recommended fastener count :
Area 4
4 (Area1) / 2 (Area2) / 4 (Area 3) / 2 (Area4)
- Vertically
y Recommended minimum fastener clearance :
At least 250mm (10")
ex. Between Area 1' s last fastener and Area 2' s
first fastener.
Installation
55
3