Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installing and charging the battery
Installing transmitter batteries
Transmitter battery installation: open the battery cover at the back of the transmitter.
Install 4pcs AA batteries according to the polarity indications (Note: batteries are not
included).
1. During the battery installation, it must be ensured that the
polarities of the batteries are matched with that of the battery box.
No battery shall be installed with the opposite polarity.
2. Please do not use new and old batteries together.
3. Please do not use different types of batteries together.
4. Do not use rechargeable batteries.
Charging the helicopter
Make sure the equipment is switched
OFF before charging.
Charging instructions: switch off the helicopter (on/off switch is at the top of the
helicopter); insert the charging cable into a USB port on your computer (the charging
cable indicator light will turn on); connect the charging cable to the helicopter (the
charging cable light will go off); the charging time is about 60 minutes; unplug the
charger cable when the light turns on.
The charging time is about 60 minutes; flying time is about 5 minutes.
Important: battery charging information
- Rechargeable batteries should be removed from the toy before being charged.
- Rechargeable batteries should only be charged under the supervision of adults.
- Exhausted batteries should be removed from the aircraft.
- Caution: Risk of explosion if battery is replaced with incorrect ones. Please dispose the
batteries according to the instructions.
Re-installing the Blades
Battery Cover
4 x AA Batteries
1. Remove the screws before re-installing
the blades.
2. A labeled blades fit on the A labeled
motors, B labeled blades fit on the B
labeled motors. Use the screws to
tighten the blades. Refer to the image.
- 18 -
Werbung
