Fenton SPD Serie Bedienungsanleitung Seite 5

OPERATION:
Connect the passive speaker with the supplied connection cable to the speaker output
connector (21). WARNING: only connected the original slave speaker on the speaker output
terminal!
If required connect an external signal source like a CD-player to LINE IN (20).
Connect the device with an electric outlet (230VAC / 50Hz).
LINE INPUT (DVD, CD-player etc.):
1. Connect the source (DVD-player, CD-player etc.) to the line input on the rear panel (20)
2. Push the input selector to Audio position
3. Volume can be controlled with master volume control
USB/SD player:
1. Push the input selector to the USB position.
2. Insert USB-stick or SD-card with MP3 files in the MP3-player.
3. MP3 files will be played after a few seconds.
4. Volume can be controlled with master volume control.
5. Previous track can be selected with PREV button on MP3-player.
6. Next track can be selected with NEXT button on MP3-player.
7. Pressing the PAUSE button on the MP3-player will pause the song and again pressed
will continue playing.
MICROPHONE:
1. Insert the microphone to the MIC1, MIC2 or MIC3.
2. Adjust the MIC volume.
GUITAR
(when available):
1. Insert the guitar to the guitar input jack.
2. Adjust the GUITAR volume.
WIRELESS MICROPHONE
1. Open the battery compartment cover. Insert battery, observing polarity
2. Re-attach the battery cover.
3. Turn on the microphone by using the power switch.
4. The battery LED indicator will light, indicating full battery strength. In the
case of a low or dead battery, the battery LED will extinguish, indicating
that the battery should be replaced with a fresh one.
5. The IR indicator in the amplifier should now be lit.
6. To preserve battery life, turn the microphone off when not in use. If you
are not going to use the microphone for a long period of time, take out
the battery from microphone to avoid possible battery leakage to
damage the microphone.
(Only for SPD-models available)
:
5