TFA Dostmann 38.2023 Bedienungsanleitung Seite 7

TFA_No. 38.2023_Anleitung
TRIPLE TIME XL – Digital Triple Timer
2.3 Back (Fig. 3)
P: Stand (fold out)
Q: Wall mount hole
R: RESET button
S: Magnet
T: Battery compartment
3. Getting started
• Open the battery compartment and remove the insulation strip.
• A short beep will sound and all LCD segments will light up for
about 2 seconds.
• The unit is now ready to use.
4. Operation
• Press CLOCK/TIMER button to toggle between clock-mode or timer-
mode.
• Press and hold HR button or MIN/12/24 HR button or SEC button,
you will enter fast mode.
• All successful settings will be confirmed by an acoustical signal.
5. Time
• Press and hold CLOCK/TIMER button in clock-mode for 3 seconds.
• In the upper display the hours, minutes and seconds indication
flashes.
• Press HR button to set the hours, press MIN/12/24 HR button to set
the minutes and press SEC button to set the seconds.
• Confirm with CLOCK/TIMER button.
• Press MIN/12/24 HR button to choose 12 HR (AM or PM appears on
the display) or 24 HR system.
12
04.03.2011 11:10 Uhr Seite 7
TRIPLE TIME XL – Digital Triple Timer
6. Stopwatch
• Press ST/SP/MEMORY button in clock-mode.
• In the middle display the 1/100 seconds will be counted.
• Hours, minutes and seconds appear in the lower display.
• Use ST/SP/MEMORY button to stop and restart the counting.
• Press CLEAR button to reset the display.
7. Count Down Timer
• In timer-mode TIMER 1 appears in the upper, TIMER 2 in the middle
and TIMER 3 in the lower display.
• Press and hold T1 or T2 or T3 to select a timer.
• A short beep will sound and the selected timer is flashing.
• Press HR button to set the hours, press MIN/12/24 HR button to set
the minutes and press SEC button to set the seconds.
• Press the respective T1 or T2 or T3 button to confirm the desired
setting.
• Press T1 or T2 or T3 button to start the count-down of the respec-
tive timer.
• Press T1 or T2 or T3 button again to stopp/restart the counting of
the respective timer.
• For simultaneous operation of all three timers set the desired time
for TIMER 1, TIMER 2, TIMER 3.
• Press ST/SP/MEMORY button to start/stop and restart the count-
down of TIMER 1, TIMER 2, TIMER 3 at the same time.
• When the timer counts down to 00:00:00, a beeping alarm
(1 min.) will sound, the display flashes and TIME'S UP appears.
• Now the timer will start to count up the elapsed time until it is
stopped by pressing ST/SP/MEMORY button or the respective
TIMER button (T1, T2, T3).
13