Viking ASP 100 Gebrauchsanleitung Seite 28

Declaration on the installation of
an incomplete machine
Technical specifications
Troubleshooting
2. Notes on the instruction
manual
2.1 General
This instruction manual constitutes
original manufacturer's instructions in
the sense of EC Directive 2006/42/EC.
VIKING is continually striving to further
develop its range of products; we therefore
reserve the right to make alterations to the
form, technical specifications and
equipment level of our standard
equipment.
For this reason, the information and
illustrations in this manual are subject to
alterations.
This instruction manual is protected by
copyright. All rights reserved, especially
the right of reproduction, translation and
processing using electronic systems.
26
38
3. Machine overview
38
39
1 Snow plough assembly
2 Locking lever
3 Lift pedal
4 Swivel rod
5 Lift rod
6 Locking lever
7 Handle
8 Coil springs
9 Slide bar
10 Gauge wheels
4. For your safety
4.1 General
These safety regulations must
be observed when working with
the ride-on mower and attached
accessories.
Read the entire instruction
manual before using the
machine for the first time. Keep
the instruction manual in a safe
place for future reference.
Please also observe the instruction
manual of the ride-on mower – particularly
the safety instructions in the section "For
your safety".
The safety instructions contained in this
instruction manual supplement the safety
instructions in the instruction manual of the
ride-on mower.
Caution – risk of accident!
The snow plough may only be used to
clear snow; its use for other purposes is
not permitted.
Risk of death from suffocation!
1
Packaging material is not a toy -
danger of suffocation! Keep
packaging material away from
children.
Always keep warning and information
stickers clean and readable. Damaged or
missing stickers must be replaced by new,
original plates from your VIKING specialist
dealer. If a component is replaced with a
new component, ensure that the new
component is provided with the same
stickers.
4.2 Before operation
Make sure that only persons who are
familiar with the instruction manual are
permitted to use the machine.
Ensure that you are familiar with all of the
controls of the accessory before use.
Before using the ride-on mower on snow
or ice-covered roads, snow chains should
be fitted on the wheels.
Snow chains are available as accessories
(see the section "Recommended
accessories").
Ensure that sufficient lighting is available
throughout the entire snow ploughing
procedure.
Familiarise yourself with the contour of the
area to be cleared beforehand. Avoid
depressions (holes, recesses, ripples,
etc.) at all times.
0478 907 9923 A - EN