Renolux optic Anleitung Seite 14

STEP 2
INSTALL the 2 SIDE BARS
1. Wrap the black strap around the rst bar (Image 1 – A) then
slip the end of the bar into the pocket (Image 1 – B).
2. Wrap the black strap around the second bar (Image 2 – A)
and slip the end of the bar into the pocket (Image 2 – B), then
insert the "male" end into the "female" end (Image 3).
STEP 3
INSTALL the MATTRESS in the BASSINET
Place the mattress in the bassinet, then take the Velcro
straps at each corner of the mattress and run them
through the buttonholes at the corners of the cot (1 &
2). Attach the velvety part of the mattress to the
hooked part under the bassinet. Only one mattress is
included, to be used either in the bassinet (if installed)
or directly in the cot (for use without the bassinet).
STEP 4
INSTALL the CLIPS
Engage the 4 clips at each corner of the cot.
ATTENTION
Be sure to check that the cot and bassinet have been
correctly unfolded and assembled before placing your
child inside. To remove the bassinet, follow these
steps in reverse.
WARNINGS
ATTENTION: Stop using the bassinet once your child
can roll from back to front or front to back, or once
your child is able to sit up.
Also, the bassinet must be removed before using the
cot's basic, lower position.
Care: Wash all fabric by hand, using a sponge and
soapy water.
(3)
(1)
A
B
(2)
B
A
(1)
(2)
13