Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4.
Connect the unit to the mains supply with the supplied mains cord. The included footswitch is
connected to the 'Remote Control Footswitch' jack on the rear of the unit with the supplied 8
m cable. After turning the STAC
After this period, the STAC
5.
Precaution
Never touch the nozzle. The nozzle ist hot, there is danger of burning yourself.
In short distance to the nozzle, the generated fog is hot too, you can scald yourself.
Take care that the safty distance between the nozzle and human beings, animals and inflama-
ble materials is always at least 60 cm.
6.
The lit green LED on the footswitch indicates that the unit is now in 'standby' mode. A fog out-
put can now be generated as long as the footswitch is depressed for a maximum contin-uous
duration of 20 seconds. After this time, the unit needs a short period of reheating which is indi-
cated by a dark LED. After the green LED is lit again, the unit is again in 'standby' mode and a
new fog output can be generated.
7.
M o re S TA C
fog generators can be connected to the unit for simultaneous trig-
®
gering by making use of the 'Slave' output. The 'Slave' output of the first STAC
simply connected to the 'Remote Control Footswitch' jack of the subsequent unit with a 3-pole
jack (stereo) cable. This way, a virtually unlimited chain of STAC
up which are simultaneously triggered by the first unit via its footswitch.
8
All manuals and user guides at all-guides.com
owner`s manual
®
Vision 1.5 on, give the unit 6 minutes for an initial heatup.
®
®
Vision 1.5 is ready for operation.
owner`s manual STAC Vision 1.5 © Zeck Audio
Vision 1.5
®
Vision 1.5 is
®
®
fog generators can be hooked
Werbung
