RIDGID NaviTrack Gebrauchsanweisung Seite 2

WARNING!
before use. Failure to understand and follow warnings and instructions may
result in electrical shock, fire and/or serious personal injury.
Description
The NaviTrack Battery Sonde is a powerful, miniaturized transmitter that can
be installed at the end of a fiberglass push cable, duct rod, or sewer cable.
The NaviTrack Battery Sonde transmits a 512 Hz signal that can be picked
up with any compatible locator which allows users to pinpoint the transmit-
ter's position underground.
Battery Installation
Unscrew the battery cover and
insert a new AAA alkaline battery,
positive end first, as shown on the
label.
Turning the Transmitter ON and OFF
• To turn the transmitter ON, fully
tighten the battery cover. The
LED will flash when the trans-
mitter is ON.
• To turn the transmitter OFF,
loosen the battery cover ¾ turn.
The LED will stop flashing when
the transmitter is OFF.
Status LED
When the transmitter is ON, the red LED will
flash slowly. When there is not enough power
for proper operation, the red LED will flash
rapidly. If the LED does not flash, or if it flashes
rapidly, replace the AAA battery.
2 - English
NaviTrack Battery Sonde
®
Read the instructions and warnings of all equipment
Red Status LED