Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Please refer to the following link: https://www.barthelme.de/shared/download/katalog/
AQUALUC-Chemische-Mittel-Chemical-Agents.pdf
The product has been tested for a maximum of 5 days in continuous underwater use. For longer
periods of underwater use we recommend our AQUALUC S:OLID underwater light line.
For more information, visit
Depending on the surface and the application, the installation can be performed with the
mounting profile (Art. 4050003x), the bracket set (Art. 4050003x), with thermal conductive
double-sided adhesive tape (Art. 30033009) or with construction adhesive (Art. 63500030).
The use of the mounting profile (Art. 4050003x) is permitted only in combination with the
technical vaseline (Art. 63500022)!
When using the bracket set it is recommended to install a bracket approx. every 25 cm to
ensure a secure holding of the AQUALUC C:URVE.
The AQUALUC C:URVE must not be fitted over joints that may expand and contract due to am-
bient conditions, except when using the non-gripping mounting profiles (item no. 40500037
or 40500038).
In particular, the thermal expansion of materials must be taken into account. It is therefo-
re recommended to use mounting profiles according to the rule: AQUALUC length in cm <
mounting profile length in one piece. Failure to observe this rule will inevitably compress or
stretch the LED light line and void the warranty.
If you use adhesive tape, please ensure that the surface to be taped is dry, even, and clean
(no fat, oil, silicone and dust particles). To achieve best adhesion, the surface of the AQUALUC
C:URVE should also be clean (if necessary clean the surface of the LED light line with a soft,
slightly damp cloth. To remove more severe stains use a standard cleansing material without
abrasive elements).
Fix the tape on the bottom side of the AQUALUC C:URVE or on the mounting surface and press
the LED light line firmly. The contact pressure should not exceed 10-15 N/cm
LEDs or the electronic parts of the AQUALUC C:URVE could be damaged.
If you select the construction adhesive then it is important to ensure an even and slight wave
form distribution. The amount of adhesive used should be relative to the size of the required
adhesive surface.
www.barthelme.de
, otherwise the
2
Werbung
