N-Gear Disco Star 710 Zilver Benutzerhandbuch Seite 6

Instruction
Key Function
- Turn on the speaker ,switch the power ON/OFF button to the left .
- Turn off the speaker ,switch the power ON/OFF button to the right .
- You will hear the voice prompt "N-GEAR makes you move".
- The unit will enter Bluetooth mode and the front LED light will flash .
- The top LED light and laser light will turn on.
- A voice prompt will advise "Bluetooth mode " to indicate you are ready to pair with your phone or Bluetooth audio
device and the LED light will flash in blue.
Alternatively , use the Remote control Speaker on/off button (21) to turn the speaker on .
Important : For the remote control to be active , the power button must be on .
LET'S PLAY MUSIC
Using Bluetooth
- Place the unit and your Bluetooth device no more than 10m apart.
- When powering on the unit, it goes into Bluetooth mode by default.
- Make sure the Bluetooth function on your device is switched on.
- Set your device to search for the Bluetooth Pairing name N-Gear Disco Star 710.
- The voice prompt "Bluetooth connected " will tell you if the paring is successful .
Using the Remote control
The 2 X AAA battery
- To get your remote control working initially , Insert 2 x AAA battery to the battery compartment located at the
bottom of the remote .
- Use the Remote control (21) button to turn the speaker on .
- You will hear the voice prompt "N-GEAR makes you move".
- The unit will enter Bluetooth mode and the front LED light will flash .
- You can use the Remote control button (1) & (2) to turn the LED lights and laser light on or off .
- The top LED light and laser light will turn on.
- Adjust the volume to your desired level by turning the volume control.
- If your remote becomes intermittent or you find you have to move closer the unit to operate ,then probably
batteries need to be replaced .
EN