Werbung
Verfügbare Sprachen
Verfügbare Sprachen
If the battery pack still fails to charge, please send
•
the charger
•
and the battery pack
to our customer service center.
To ensure that items are properly packaged
and delivered when you send them to us,
please contact our customer service or the
point of sale at which the equipment was
purchased.
When shipping or disposing of batteries and
cordless tools, always ensure that they are
packed individually in plastic bags to prevent
short circuits and fi res.
To ensure that the battery pack provides long ser-
vice, you should take care to recharge it promptly.
You must recharge the battery pack when you
notice that the performance of the device drops.
Never allow the battery pack to become fully di-
scharged. This will cause it to develop a defect.
5.6 Battery capacity indicator (Fig. 9)
Press the button for the battery capacity indicator
(A). The battery capacity indicator (B) shows the
charge status of the battery using 3 LEDs.
All 3 LEDs are lit:
The battery is fully charged.
2 or 1 LED(s) are lit:
The battery has an adequate remaining charge.
1 LED fl ashes:
The battery is empty, recharge the battery.
All LEDs blink:
The battery temperature is too low. Remove the
battery from the equipment, keep it at room tem-
perature for one day. If the fault reoccurs, this me-
ans that the rechargeable battery has undergone
exhaustive discharge and is defective. Remove
the battery from the equipment. Never use or
charge a defective battery.
6. Operation
Important: Make sure that the hose is under
pressure only during use. When the work is fi -
nished, turn off the water supply and empty the
hose before winding it up.
GB
6.1 Winding out
Important! To avoid damaging the equipment,
pay attention to the mark for the maximum pull-
out length.
•
Pull out the desired length of hose from the
cordless hose reel. The hose can be latched
in any position.
•
Important: To prevent damage, pull on the
hose or the stopper and not on the spray
nozzle.
•
Check if the spray nozzle is closed and then
open the water supply.
•
The hose is now ready for use and you can
start with your work. Infinite adjustment of the
water jet from no water to fine spray and to
strong jet is possible by turning the front part
of the spray nozzle.
6.2 Winding up
•
When you are finished with your work, close
the spray nozzle first and then the water sup-
ply. Before you wind up the hose, open the
spray nozzle again to release the remaining
water pressure and take the strain off the
hose.
•
Go with the end of the hose back to the hose
reel and press the On/Off switch (Fig. 1 / Item
3) in order to start the wind-up operation.
Allow the hose to be fully wound up or stop
the hose reel at any position for the length of
hose you want.
•
Protection function: The cordless hose reel
will switch off automatically if it experiences
any resistance. To restart, switch on the hose
reel again by pressing the On/off switch (3).
•
If the hose becomes blocked, pull the hose
completely out of the hose reel and have it
wind up again. Take care to keep the twisting
of the hose to a minimum.
7. Cleaning, maintenance and
ordering of spare parts
The equipment is largely maintenance-free. How-
ever, we recommend regular checks and product
care in order to ensure a long service life. The
inside of the hose reel housing is not allowed to
be cleaned with fl owing water, especially not at
high pressure.
Danger!
Always pull out the battery before starting any
maintenance and cleaning work.
- 20 -
Werbung
