Avermedia AM310 Kurzanleitung Seite 22

Federal Communications Commission Statement Class B
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
NOTE - This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by tuning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/television technician for help.
CAUTION ON MODIFICATIONS - To comply with the limits for the Class B digital device, pursuant
to Part 15 of the FCC Rules, this device must be installed in computer equipment certified to
comply with the Class B limits. All cables used to connect the computer and peripherals must be
shielded and grounded. Operation with non-certified computers or non-shielded cables may result
in interference to radio or television reception.
Changes and modifications not expressly approved by the manufacturer or registrant of the
equipment can void your authority to operate the equipment under Federal Communications
Commission rules.
European Community Compliance Statement Class B
This product is herewith confirmed to comply with the requirements set out in the Council
Directives on the approximation of the laws of the Member States relating to Electromagnetic
Compatibility Directive (EMC) 2014/30/EU.
Waste Electrical and Electronic Equipment Directive
The mark of crossed-out wheeled bin indicates that this product must not be disposed of with your
other household waste. Instead, you need to dispose of the waste equipment by handing it over
to a designated collection point for the recycling of waste electrical and electronic equipment. For
more information about where to drop off your waste equipment for recycling, please contact your
household waste disposal service or the shop where you purchased the product.
CAN ICES-3(B)/NMB-3(B)
Canada - Canada Industry Canada (IC) Labelling Requirements
Every manufacturer or importer shall ensure import or before offering for sale, as appropriate,
that each unit of the type that they offer for sale bears, in alocation convenient for inspection, a
permanent label or marking containing (in French and English), the following statement:
ICES-003 (Interference - Causing Equipment Standards)
"This class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada."
Technical Regulations of the Customs Union
TR CU 020/2011
TR CU 004/2011
MSIP Class B Statement (Korea)
B급 기기 (가정용 방송통신기자재): 이 기기는 가정용(B급) 전자파적합기기로서 주로 가정에서 사
용하는 것을 목적으로 하며, 모든 지역에서 사용할 수 있습니다.
Class B (For Home Use Broadcasting & Communication Equipment): This equipment is home use
(Class B) electromagnetic wave suitability equipment and tobe used mainly at home and it can be
used in all areas.
MSIP-REM-
AVM-AM310
Regulatory Compliance Mark