Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ND 1400 QUADRA-CHEK
Installation Instructions
Operating Instructions available at www.heidenhain.de
Electrical connection
Warning! Risk of electrical shock
A risk of electrical shock exists if this product is not properly grounded.
To avoid the hazard, always use a 3-conductor (grounded) power cord and
ensure the ground is properly wired to the building installation.
Warning! Risk of fire
A risk of fire exists if a power cord not meeting minimum specifications is
used.
To avoid the hazard, always use power cords that meet or exceed the minimum
listed specifications.
Connecting a power cord
To connect a power cord:
Verify that the power switch is in the off position
X
X
Verify that the power cord is not plugged into the main power supply
X
X
Insert the female end of the power cord into the power connector on the rear of the
X
X
product
Insert the male end of the power cord into the the main power supply outlet
X
X
Data interface connections
Notice
This product contains components that can be damaged by electrostatic
discharge (ESD). Observe precautions for handling ESD sensitive devices and
never touch connector pins unless properly grounded.
Connecting a 5-pin touch probe
This product provides a connection for a 5-pin touch probe.
To connect a 5-pin touch probe cable:
Verify that the power switch is in the off position
X
X
Insert the interface cable into it's connector
X
X
Connecting a foot switch
This product provides an RJ-45 foot switch connection for use with a HEIDENHAIN foot
switch (ID 681041-01).
To connect an RJ-45 foot switch cable:
Verify that the power switch is in the off position
X
X
With the cable connector locking tab aligned with the connector, insert the cable
X
X
connector into the interface connector until the tab locks into place
All manuals and user guides at all-guides.com
Observe ESD handling precautions
6
5-pin touch probe connector
8
Foot switch connector
15
Werbung
