Clevo CG-KN2 Bedienungsanleitung Seite 4

English Version
Connection
First Use
Please make sure the N-S is powered on and has been upgraded to the
latest version before use this product.
1. Turn on the N-S.
2. Press and hold Y + HOME buttons at the same time for 2 seconds.
3. The 4 LED lights will flash. When the connection is successful, the
corresponding LED light will keep on. If the connection is unsuccessful,
the controller will enter hibernate mode after 90 seconds.
* For Android devices, press and hold A + HOME to connect the devices.
Use Again
1. Turn on the N-S.
2. Press the HOME button for 1 second to wake up the controller.
3. N-S will connect the controller automatically. When the connection is
successful, the corresponding LED light will keep on. If the connection is
unsuccessful, the controller will enter sleep mode after 10 seconds.
4. Press other buttons cannot wake up the controller.
Charge
1. When the controller is off, the 4 LED lights will flash slowly during
charging. The LED lights will turn off when it is fully charged.
2. When using the controller, the current LED indicator light will flash
quickly if the battery is low, and it will turn to slow when it is in charging.
3. The pair indicator light and reconnect indicator light have higher
priority when they conflict with charge indicator light and low battery
indicator light.
Auto Sleep
1. The controller will enter sleep mode automatically when the screen is
off.
2. The controller will enter auto sleep mode if no button been pressed
or no movement been detected for 5 minutes.
1