Programming A Sensor For A Drive With A Built-In Radio Receiver - Krispol Starcus Bedienungsanleitung

8. PROGRAMMING A SENSOR FOR A DRIVE WITH A BUILT-IN RADIO RECEIVER

In order to program the devices, we need to upload at least 1 transmitter.
!
Remember to correctly set the drive operation directions.
1x
Press the The blind
PROGRAMMING emits a beep.
(P2)button once
A correctly programmed remote control works as follows: the up button closes the blind.
!
9. LIGHT / WIND INTENSITY DISPLAY
In order to display
the current value of
light intensity, press
the adjustment (A)
button.
10. LIGHT / WIND INTENSITY DISPLAY CHECK
In order to check the
activity of the light
sensor, press the
menu (M) button.
11. LIGHT / WIND SENSOR VALUE ADJUSTMENT
In order to start adjusting the
value of the light intensity sensor,
press and hold the menu (M)
button for 2 seconds.
1x
Press the
PROGRAMMING
(P2) button once.
The value is reduced by pressing Press the menu (M) button again
the adjustment button (A) and
increased by pressing the (UP)
button.
The blind
emits a beep. PROGRAMMING (P2)
In order to display the
current value of wind
intensity, press the
adjustment (A)
button again.
In order to check the
activity of the wind
sensor, press
the menu (M)
button again.
The value is reduced by pressing
to start the wind sensor value the adjustment button (A), and
adjustment. the value increased by pressing
1x
Press the The blind emits
a few beeps.
button once.
Pressing the menu button (M)
is followed by quitting the
sensor control mode.
the UP button.
The sensor
has been
programmed.
In order to display the
current value of wind
and light intensity,
press the adjustment
(A) button again.
Pressing the menu (M) button
is followed by quitting the
sensor adjustment mode.