Duravit SensoWash 254459-Serie Montageanleitung Seite 8

Mounting instructions information
These mounting instructions come as part of
the Duravit shower toilet and should be read
carefully prior to installation.
Target readership and qualifications
The shower toilet and associated water
connection should only be installed by
qualified plumbers. The electrical installation
should only be carried out by qualified
electricians.
Explanation of the key words and symbols
Indicates a hazardous situation
DANGER
which, if not avoided, will
result in death or serious
injury.
Is used to address practices
NOTICE
not related to physical injury.
Link to the Electrical installation
section
Link to the mounting instructions in
this section
Link to the Water Installation section
Link to other instructions
Inspection (e.g. for scratches)
Do not kink hose
Check for leaks
Flush
> Action required
8
56918_MAL_SeWa_WWC+Montageset#100691_100730/19.11.5
Safety instructions
Risk of fatal electric shock
> Do not remove individual SensoWash
components.
Product and/or property damage
The breach of local and country-specific
regulations and standards can cause damage
to the product and/or property damage.
> Observe the local installation regulations
and any country-specific standards at all
times.
Product damage
> Do NOT install the shower toilet in rooms
where there is a danger of frost. The room
temperature must not be less than 4 °C (39
°F) .
Mounting instructions
These instructions describe the installation of
the SensoWash wall-mounted toilet with an
installation kit for front-wall elements with
ductwork. The instructions enclosed with the
wall-mounted toilet are only valid for the wall-
mounted toilet without an installation kit and
should therefore be disposed of.
The shower toilet seat installation is described
in separate instructions.
+
Checking the pre-installation
8 45
> Check whether the push plate of the front-
wall element and wall-mounted toilet are
disassembled. Disassemble other elements
if necessary.
> Check whether the electrical installation has
already been carried out.
+
Drilling a hole to the ductwork in the
9 46
front-wall element
> Take clearances x and y to the front-wall
element from the documentation.
> Mark the drill holes.
> Drill a hole to the ductwork.
®