AYR 763 Benutzerhandbuch Seite 14

6. Device addition and network configuration
1- This device can only work with a 2.4GHz Wi-Fi signal. So please
check your router and make sure it works at 2.4GHz. When setting
up the network, please keep the product and mobile phone as close
as possible to the wireless router to ensure a good network signal.
2- Please perform the following steps 1-4 in strict order.
3- In the process of network configuration, if you hear the host mes-
sage "configure network timeout" or the interface shows that the ne-
twork configuration fails, please exit the application and restart the
product, and then operate again from step 1.
Step 1: Open and log in the application, click "add device" and se-
lect "Camera & Lock" in the product catalogue on the left, as shown
in (figure 1). Then select "Smart doorbell" in the product type on
the right, and the interface will appear as shown in (figure 2).
14
1 2
EN