AYR 763 Benutzerhandbuch Seite 12

3. How to install the device on the door
Step 1: According to the thickness of the door to select a
suitable bolt, then, screw the boltinto the hole (refer installation
icon 1)
Step2: Tear off double-side adhesive protective film on the
back of the outdoor part, insertthe unit barrel together with the
FPC cable through the peephole of the door, then stick the
outdoor part on door(motion detection is upward, doorbell key is
downward)
1
Step3: Take out the metal bracket (the "UP" arrow on the bracket
means upward), pass the FPC cable through the rectangular
hole, the right screw through the round of the metal bracket, then
lock the metal bracket with the outdoor unit tightly.
Step4: Insert the microSD card (not included) into the indoor unit
if using one.
Step5: Connect the FPC cable from outdoor part to the
connector of the indoor part (pay attention to the right direction)
Step6: The four slots on the back of indoor part is aligned with
four projection on metal bracket and buckle up, then pull down
the outdoor part to lock tightly.
12
FPC cable
Screw
outdoor unit
4 5
connector
door
2 3
outdoor unit
door
indoor unit
FPC cab l e