Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1
2
BEFORE CONNECTING
Clean and remove rust-streaked and oxidized areas on the contact points of the battery and the ground connection. Make sure that all
screws are fixed tight after the installation, because loose connections cause malfunctions, insufficient power supply or interferences.
BATTERY
1
Connect the red cable of the wiring harness plug with the +12V pole of the vehicle's battery
REMOTE
2
Connect the blue cable with the turn-on remote signal of your head unit. Hereby the sound system turns on or off with your head
unit.
NOTE: This connection is only required, if you want to use the remote wire from the head unit to turn the sound system on and
off and the switch AUTO TURN ON is in position REM. Please refer also step #6 on the following page.
GROUND
3
Connect the black cable of the wiring harness plug with a suitable contact ground point on the vehicle's chassis. The ground wire
must be as short as possible and must be connected to a blank metallic point at the vehicle's chassis. Ensure that this ground
point has a stable and safe electric connection to the negative "–"pole of the battery.
FUSE
4
The inserted fuse (15A) protects the sound system from shorts and capacity overload. If you need to replace the defective fuse,
use a fuse with the same fuse value.
INSTALLATION INSTRUCTIONS
ELECTRICAL INTERCONNECTION
A 690 RXA
300 WATTS MAX.
RED
BLUE
CONNECT WITH THE REMOTE
CABLE OF THE HEAD UNIT
SHI FT
L E VEL
0°
LOW
180°
HIGH
MIN.
MAX.
L OW
P AS S
R EMOT E
POWER
PROTECT
50 Hz
150 Hz
POWER
INPUT
BA S S
BOO S T
0 dB
12 dB
L EVEL
TUR N ON
REM
DC OFFSET
AUTO
AUDIO
INPUT
4
FUSE
ENCLOSED
WIRING HARNESS
WITH PLUG
BLACK
3
11
Werbung
Inhaltsverzeichnis
Fehlerbehebung
