Werbung
General safety information
– Only an electrician may carry out mounting .
– Only fastening elements which are tested and ap-
proved for fire may be used for mounting .
– Before working on power cables, ensure that they are
deenergised and secure them against unintentional
switch-on!
In-housing fastening T...
– Create at least two diagonal base openings for later
wall glands .
– Draw the drill holes .
– Drill holes: Ø 5 mm, depth 60 mm . Clean the drill holes
well (Figure
– Pass the supplied fire protection screw ties through
the connection unit first, then through the sealing
washer, and then screw them directly into the sub-
strate through the base opening without anchors (Fig-
ure
4
) . Tightening torque max . 3-8 Nm .
External shackle fastening T...A
We recommend using OBO fire protection screw ties
MMS 6x50 for fastening .
– Draw the drill holes .
– Drill holes: Ø 5 mm, depth 60 mm . Clean the drill holes
well (Figure
– Fasten the FireBox using the fire protection screw ties
5
(Figure
) . Tightening torque max . 3-8 Nm .
3
) .
3
) .
EN
11
Werbung
