Werbung
Verfügbare Sprachen
Verfügbare Sprachen
■
A damaged mains cable may only be replaced by the manufacturer, a workshop com-
missioned by the manufacturer or a similarly qualified person, so as to prevent any
danger.
■
Ensure that cables are not pinched, kinked or damaged by sharp edges.
■
Always lay cables so that nobody can trip over or become entangled in them. This poses
a risk of injury.
5.6 Operating environment
■
Use the appliance only in dry environments. Do not use in bathrooms or similar wet/hu-
mid environments.
■
Do not place the product under any mechanical stress.
■
Protect the appliance from extreme temperatures, strong jolts, flammable gases, steam
and solvents.
■
Protect the product from high humidity and moisture.
■
Protect the product from direct sunlight.
5.7 Installation
■
Folding beds hinges can damage the mains cable, the controller unit, and the appliance.
Keep mains cable, controller unit, and appliance away from hinges when folding.
■
Do not use safety pins or other spiky and sharp objects to the fix the appliance.
■
Do not puncture the appliance.
■
Do not pierce the appliance.
5.8 Operation
■
Do not use the appliance unsupervised.
■
Heat can cause skin burns. Do not use the appliance at high settings over extended peri-
ods of time.
■
Stop to use if you experience discomfort. If discomfort persists, consult your doctor.
■
Concentrated heat can cause fire. Fully unfold the appliance before using.
■
Do not carry the appliance by the mains cable.
■
Do not touch the appliance if it has fallen into water. Unplug the mains plug before re-
moving the appliance from the water.
■
Consult an expert when in doubt about the operation, safety or connection of the
product.
■
If it is no longer possible to operate the product safely, take it out of operation and pro-
tect it from any accidental use. DO NOT attempt to repair the product yourself. Safe op-
eration can no longer be guaranteed if the product:
– is visibly damaged,
– is no longer working properly,
– has been stored for extended periods in poor ambient conditions or
– has been subjected to any serious transport-related stresses.
5.9 Storage
■
Concentrated heat can cause fire. Let the appliance cool down to room temperature be-
fore folding.
6 Installation
1. Spread the underblanket across the top of the mattress. CAUTION! Completely unfold
to prevent fire.
2. Secure the underblanket at each corner with one of the elastic straps.
3. Put a bed sheet on top of the underblanket.
4. Connect the 4-pin plug of the control unit to the socket on the underblanket.
à
The underblanket is installed and ready for use.
7 Operation
Switch on the underblanket 30 minutes before going to bed. You can select between differ-
ent temperature settings. The underblanket switches off automatically after 180 minutes of
continuous use at any temperature setting.
Temperature settings:
Controller switch
Temperature setting For continuous use
position
1
Low
2
Medium
3
High
Preconditions:
a
Underblanket is completely unfolded.
1. Cover the underblanket with the bed cover or duvet.
2. Connect the mains plug to a suitable mains socket.
3. Move the controller switch to the desired temperature setting (1-3).
à
The switch setting indicator lights up.
à
The underblanket heats up.
5
Yes
Not suggested as underblanket becomes
very warm
Not suggested as underblanket becomes
very warm
4. Before you go to bed, move the controller switch to temperature setting 1.
à
The underblanket will switch off after 180 minutes of continuous use.
5. After use or if the underblanket has switched off automatically, move the controller switch
into position 0.
6. Remove the mains plug from the mains socket if you do not use the underblanket.
8 Cleaning
Important:
– Do not use aggressive cleaning agents, rubbing alcohol or other chemical solutions.
– Maximum water temperature 30 °C.
– Do not tumble dry.
– Do not dry-clean.
– Do not iron.
1. Disconnect the underblanket from the power supply.
2. Let the underblanket cool down to ambient temperature.
3. Detach the 4-pin plug from the socket on the underblanket.
4. Wash the underblanket at max. 30 °C in the washing machine or by hand. Use mild de-
tergents.
5. Stretch the underblanket out and let it dry in the open air. Do not use a hair-dryer to dry.
6. Fold the underblanket and store it in a dry location. Do not put items on top of the under-
blanket.
9 Disposal
This symbol must appear on any electrical and electronic equipment placed on
the EU market. This symbol indicates that this device should not be disposed of
as unsorted municipal waste at the end of its service life.
Owners of WEEE (Waste from Electrical and Electronic Equipment) shall dispose
of it separately from unsorted municipal waste. Spent batteries and accumulators,
which are not enclosed by the WEEE, as well as lamps that can be removed from
the WEEE in a non-destructive manner, must be removed by end users from the
WEEE in a non-destructive manner before it is handed over to a collection point.
Distributors of electrical and electronic equipment are legally obliged to provide free take-
back of waste. Conrad provides the following return options free of charge (more details on
our website):
■
in our Conrad offices
■
at the Conrad collection points
■
at the collection points of public waste management authorities or the collection points
set up by manufacturers or distributors within the meaning of the ElektroG
End users are responsible for deleting personal data from the WEEE to be disposed of.
It should be noted that different obligations about the return or recycling of WEEE may apply
in countries outside of Germany.
10 Technical data
Input voltage .................................. 220 - 240 V/AC
Input AC frequency ........................ 50/60 Hz
Power consumption ....................... 55 - 60 W
Auto-off function ............................. Yes; after 180 min;
Temperature settings...................... 3 temperature settings
Material........................................... double-sided non-woven fabric; washable;
Operating temperature .................. -5 to +40 °C
Operating humidity ........................ 20 - 80 % RH (non-condensing)
Storage temperature ...................... -5 to +55 °C
Storage humidity ............................ 20 - 80 % RH (non-condensing)
Dimensions (L x W) ........................ 1500 x 900 mm
Weight (approx.) ............................ 0.96 kg
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method (e.g. photocopying, microfilming or the capture in
electronic data processing systems) requires prior written approval from the editor. Reprinting, also in part, is prohibited.
This publication reflects the technical status at the time of printing.
Copyright by Conrad Electronic SE.
*2859458_V1_0623_jh_mh_en 27021598646472587-2 I4/O1 en
Werbung
