Maintenance; Lubrication; Safety Instructions For Lubrication - Weh TW156 Bedienungsanleitung

AE Operating instructions
9�4

Maintenance

Please note: Subsequent mentions of descriptions and position numbers refer to
Chapter 3. Product overview / product description on page 11.
Î
If you detect any leaks or malfunction, replace the WEH
for maintenance. Stop using the product immediately.
The following maintenance work may be carried out by the operator:
Î
Check the WEH
ment, sufficant lubrication, wear, contamination and damage.
Î
Regularly check the clamping jaws for dirt accumulation. Dirt particles can interfere
with the clamping and sealing function, posing a potential hazard.
Î
Check the tightening torque of the grub screw (Pos. 5) at the V-actuation.
Tightening torque 0.5 Nm.

10. LUBRICATION

Please note: Subsequent mentions of descriptions and position numbers refer to
Chapter 3. Product overview / product description on page 11.
10�1

Safety instructions for lubrication

Î Take care not to damage sealing surfaces or sealing components when lubricating.
Î Only use WEH
®
10�2 Lubrication
Figure 15
Page 24
MD-10021-L51-R2.1.0-03
Product for leak tightness and correct functioning – ease of move-
®
Maintenance spraypart no. E99-44923 for lubrication.
Î
Apply a short burst of spray with the aiming tube to the
actuator peg (Pos. 3) (Figure 15).
Attention: The lubricant must not be allowed to enter the
gas channel.
Product or send it to WEH
®