Petsafe RF-275 Bedienungsanleitung Seite 3

Inserting the Battery in the Receiver
Using a Phillips head screwdriver, remove the
four screws from the back cover and take the
cover off of the receiver. Once open, connect a
9-volt alkaline battery to the battery connector.
Place the connected battery into the receiver
and replace the back cover.
Correction
Testing the System
Level Switch
Changing the Correction Level - The correction
levels change incrementally from the current
level and revert back to 1 from 5. Refer to the
Receiver LED Function and Response table
to choose the correction level that best fi ts
your pet. Remove the switch cover with a small
coin. With battery installed, press the small
button (correction level switch) on the receiver until the LED lights
and release. The LED will then fl ash to show the current correction
level. To change to the next level, push the button in again once the
last fl ash has been displayed. Please note that the button must be
3