Troubleshooting - D+H ZA 35-K-BSY+(-HS) Originalbetriebsanleitung

Troubleshooting

Visual inspection:
Only one master-drive allowed.
The master has, according to common drives,
the last adress.
The adress is sticked on the drive. Slaves are
nubered downwards.
Example: In a group, composed of 3 drives,
there is a master 3, a slave 2 and a slave 1drive.
Attention: only applies by factory set. as soon as
the drives were reprogramized with SW-BSY+
he factory set adressing does not apply any
longer.
Wiring:
Is the group wired correctly? Please refer to the
connection diagrams in this regard
Adjustment of zero point:
Adjust the zero point.
Software SW-BSY+ with BI-BT1 or the
special magnet MAG 502 is required
Call D+H Service:
Drives must be configured.
Software SW-BSY+ and BI-BT1 incl. connection
cable (30.006.23) is required
Maintenance and cleaning
Inspection and maintenance has to be carried out
according to D+H maintenance notes. Only original
D+H spare parts may be used. Repair is to be carried
out exclusively by D+H.
Wipe away debris or contamination with a dry, soft
cloth.
Do not use cleaning agents or solvents.
Declaration of Conformity
We declare under our sole responsibility that the
product described under "Technical Data" is in
conformity with the following directives:
2004/108/EC, 2006/95/EC
Technical file at:
D+H Mechatronic AG, D-22949 Ammersbek
Thomas Kern
Member of the Board
12.06.2010
99.823.99 1.1/07/11
Maik Schmees
Authorized signatory, Technical Director
Functional description
A synchronous group ZA-K-BSY+ (-HS) can contain
up to 4 drives, which communicate via bus. Each
drive has its own address, configurable with SW-
BSY+ and BI-BT1. The last drive of a synchronous
group is the master, which controls the other drives,
the slaves. Differences in forces between the drives
of a group are balanced by means of intelligent force
and position control. In the event that a drive
malfunctions, all the drives are automatically cut off.
Guarantee
You will get 2 years guarantee
from date of verified handing over of the system up to
maximal 3 years after date of delivery, when
mounting and starting has been carried out by
authorized D+H-distributor.
D+H guarantee is expired, with connection of D+H
components with external systems or with mixing of
D+H products with parts of other manufacturers.
Disposal
Electrical devices, accessories and packaging
should be sorted for environmental-friendly recycling.
Do not dispose electrical
devices into household waste!
Only for EC countries:
According the European Guideline
2002/96/EC for waste electrical and
electronic equipment and its implemen-
tation into national right, electrcal
devices that are no longer usable must be collected
separately and disposed of in an environmentally
correct manner.
English
for all D+H products
an
9/20
ZA-K-BSY+