ZyXEL Communications NSA310 Schnellstartanleitung Seite 6

Connect the NSA
1. Use the included Ethernet cable to connect the
LAN port on the rear of the NSA to a computer,
switch, or router on your network.
2. Connect one end of the power cord
to the POWER socket on the rear of
the NSA and the other end to the
external power supply. Connect the
external power supply to a power
outlet.
Use ONLY the included power
adapter.
3. Press the power button on the front of the NSA to turn it on. Look at
the front panel lights.

If no lights turn on, make sure the power cord is not loose and that the power
source is turned on.
• The power button light turns steady blue.
• The SYS light turns steady green after a successful
startup (it takes about 50 seconds).
• The HDD lights come on if the NSA detects hard
drives in the disk bays.
• The rear panel LAN port has a light that turns on if
the Ethernet port is properly connected to your network. It blinks
while sending or receiving traffic.
To turn off the NSA, press the power button in and hold it until you hear a beep.
Then release the button.
6