ZyXEL Communications NSA310 Schnellstartanleitung Seite 5

2. Place the NSA on a flat surface with the
bottom panel facing up. This exposes the
bottom panel where the thumbscrew is
located. Loosen the thumbscrew using a flat
head screwdriver or a coin.
3. Bring the NSA to an upright position and take
off the front lid to open the hard disk tray as
shown in the following:
4. Slide in the hard disk into the tray until the
hard disk is fitted snugly inside the NSA.
5. Attach the front panel to cover the hard disk tray.
Place the NSA on a flat surface with the bottom
panel facing up and tighten the screw.
If you want to use two hard drives and configure them as
RAID volumes, you should have: 1) a SATA hard disk
installed inside the NSA; and 2) an eSATA hard disk with
its cable. It is also recommended to use the same disk size
and model for best performance. Refer to the User's Guide
for the steps to create volumes on your NSA.
5