HERKULES HBH 1000 Bedienungsanleitung Seite 7

Anleitung HBH 1000 Herkules
1. Layout (Fig. 1)
1 Dust guard
2 Locking sleeve
3 On/Off switch
4 Additional handle
5 Rotation stop
6 Drilling depth stop
7 Hammer stop
2. Technical data
Mains voltage: 230 V ~ 50 Hz
Power:
Idle speed:
Hammer rate:
Drilling capacity (max.): Concrete/Stone 26 mm
Weight:
Vibration:
Sound pressure level:
Sound power level: 103,9 dB(A)
Protection class:
The noise and vibrations from this tool were measu-
red in accordance with EN 50144-2-6. This hammer
drill is not intended for use outdoors as defined in
Article 3 of the Directive 2000/14/EC.
3. Safety rules
Important! When using electric tools it is essential
that you comply with the following basic safety rules
for the prevention of electrical shock and risk of injury
or fire.
Please read these directions for use carefully before
you start to use this tool, and put all the information
into practice.
Check that your mains voltage is the same as
that marked on the rating plate.
If you use a cable reel, run all the cable off the
reel. The minimum conductor cross section used
should be 1.5 mm 2 .
If you use this electric hammer drill outdoors you
must connect it using a suitable H07RN-F 3G
1.5 mm 2 extension cable with a spray-water
protected plug.
Make sure of your footing, particularly when
working free-handed on ladders or scaffolding.
Use a detector to localize pipes and/or cables in
30.07.2003 9:18 Uhr
walls with concealed electric, water or gas lines.
Avoid any contact with conducting electrical parts
or lines.
Wear ear-muffs to protect your hearing: Risk of
progressive loss of hearing!
Wear goggles and use a breathing mask on
dusty jobs.
Never use the machine near vapors or
combustible liquids.
Always unplug the machine before cleaning it or
changing drill bits etc.
Keep the power cable safe from damage. Oil and
acids can damage cables.
Never overload the machine.
1010 Watt
Important!
850 min -1
Follow all safety regulations in your country appli
4500 min -1 cable to the installation, use and maintenance of
the machine.
Chisel bits and drill bits can be inadvertently
6,14 kg
thrown out from the machine and cause serious
injury:
7,4 m/s 2
Always check that the chisel bit or drill bit is firmly
90,9 dB(A)
locked in the chuck before you start work.
Check the chuck for wear or damage at regular
intervals.
/ II
Do not start a hammering tool until it is pressed
against a workpiece (wall, ceiling, etc.).
Always unplug the hammer drill when you have
finished working and remove the chisel bit or drill
bit from the tool.
Always unplug the machine before changing
chisel bits or drill bits etc.
Protect eyes and assistants from small flying
parts and splinters. Wear a helmet! Erect a
screen wall!
Use workgloves to protect fingers from crushing
and skin from grazing.
Vibrations can be harmful to the hand-arm
system: Keep the impact time of vibrations to a
minimum.
Always keep the power cable away from where
you want to drill.
Keep the machine out of children's reach.
Always hold the machine with two hands when it
is running and make sure of your footing.
You will find additional safety rules for the
use of electric tools in the enclosed booklet.
Seite 7
GB
7