Commend OD1 V CM Produktanleitung Seite 174

commendStationOutputTable
Digital input
States: Short, Open
Multistate input
States: Short, R560, R1K, R1K5, R2K2, R2K7, R3K3, R4K7, R6K8, R8K2, R10K, R15K, R22K, R33K, R56K, Open
4-state input
States: Short, R3K3, R15K, Open
Microphone detection
States: NoMic, Mic, Line
Digital output
States: On (physical output is active, also if blinking or in sequence), Off (physical output is inactive, also if blinking or in sequence)
Traps
Variable binding 1: Every trap is sent with the variable binding 1 heading "sysUpTime" ("iso.org.dod.internet.mgmt.mib-2.system.sysUpTime").
Trap name Variable binding 2
Name
Application Start snmpTrap
OID
1.3.6.1.6.3.
1.1.4.1
1.3.6.1.4.1.37568.2 Sequence
.1.5.20 "OutputTableEntry"
Value
commendStationObjectStatusNoti
fications
1.3.6.1.4.1.37568.2.10
Output states OutputTableEntry = {
outputName,
outputState
}
WS 301V CM, WS 303V CM, WS 311V CM, WS 311V CM
none
OD10 TD CM:
OD10-<Serial>-output1 = see "digital output"
OD10-<Serial>-output2 = see "digital output"
OD5 TD CM:
none
IM6:
IM6-<Serial>-output1 = see "digital output"
IM6-<Serial>-output2 = see "digital output"
OD1 CM:
none
OD1 V CM:
none
EB3E2A:
EB3E2A-AUD-<Serial>-output1 = see "digital output"
EB3E2A-AUD-<Serial>-output2 = see "digital output"
EB1A:
EB1A-<Serial>-output1 = see "digital output"
EB1E1A:
EB1E1A-<Serial>-output1 = see "digital output"
IP Secure Connector:
IP CON-<Serial>-output1 = see "digital output"
IP CON-<Serial>-output2 = see "digital output"
IP CON-<Serial>-output3 = see "digital output"
Variable binding 3
Name Value
commendStationApplicationS
tart
1.3.6.1.4.1.37568.2.20
DA: