Setup And Operation; Technical Specifications - Antari Z-50 Bedienungsanleitung

-Setup and Operation

TRANSMITTER RECEIVING UNIT
Connection cable
On/Off
Control LED
Clip
6.3 mm plug
-Receiving unit
Attach the magnetic base of the receiving unit to your fog machine. Connect the 6.3 mm
plug of the receiving unit to the corresponding input jack on the fog machine.
-Transmitter
With the transmitter it is possible to emit fog via radio over a distance of up to 50 meters. Up
to 6 fog machines can be operated via one transmitter. For this purpose, however, keep the
receiving units at least 2 meters apart. Slide the transmitter's clip upwards until it locks.
Keep any of the two red buttons pressed, to emit fog [continuous operation with 100 % fog
volume]. The red control LED lights. As soon as you release the button, the fog output will
stop.
-Battery change on the transmitter
If the range of the transmitter decreases, the battery is probably exhausted and must be
replaced. For this purpose, screw off the housing cover and remove the used battery.
Insert a 12 V battery, type 23A as indicated in the battery compartment and refit the

-Technical Specifications

-Transmitter
Carrier frequency:. . . . . UHF 433.920 MHz
RF power output: . . . . . 10 mW
Range: . . . . . . . . . . . . . approx. 50 m
Battery: . . . . . . . . . . . . . 12 V, type 23A
Dimensions (LxWxH):. . 60 x 40 x 16 mm
Weight: . . . . . . . . . . . . . 30 g
-Receiving unit
Compatible with: . . . . . . Z-800II, Z-1000II, Z-1020
Cable length: . . . . . . . . 350 mm
Connector: . . . . . . . . . . 6.3 mm jack
Dimensions (LxWxH):. . 90 x 48 x 25 mm
Weight: . . . . . . . . . . . . . 80 g
Please save these instructions.