Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3 Operating
1. Connect the adapter cable to the corresponding cable on the device.
2. Plug the home adapter into an electric outlet.
3. Turn on the device using the controller ( instructions on page 16 ).
4. If necessary, add the extension part to adjust the length that fits you.
• This device will switch off automatically after 30 minutes timer run out.
• Do not setup or use the massager in a bathroom or similary wet / damp areas.
• For your own safety we equip the massager with a protection against
over-heating.Heat is created in the motors when placed under great stress
and excessive pressure. Before this could create any risk and after a runtime
of 30 Minutes. The massager will switch off automatically and will only allow
switching on again after an appropriate downtime.
• Likewise, you should allow your body some rest periods. To avoid straining
your muscles too much, we recommend to not exceed a continuous massage
of 30 Minutes.
3.1 Controller Instructions
Press to turn on
or off the massage belt
Press to change
between M1 to M3
ON/OFF
MODE
massage mode
POWER
INT
Press to set the
massage intensity,
INTENSITY I/II
at Low or High
MODES I/II/III
HEAT
Press to set the
HEAT I/II
heat level I or II
16
Werbung
