Safety Instructions; Description And Function; Disposal Instructions - Wentronic Goobay 55497 Betriebsanleitung

EN User Manual
LED light Blowing Control

1 Safety Instructions

1.1 General
• Read the user manual completely and carefully before use.
The user manual is part of the product and contains important information for
correct use.
• Keep this user manual.
The user manual must be available for uncertainties and passing the product.
• Do not modify product and accessories.
• Do not short connectors and circuits.
The LED cannot be replaced.
• Use product, product parts and accessories only in perfect condition.
• In case of questions, defects, mechanical damage, trouble and other
problems, non-recoverable by the documentation, contact your dealer or
producer.
Target group information
Not meant for children. The product is not a toy!
• Secure packaging, small parts and insulation against accidental use.
• Avoid stresses such as heat and cold, moisture and direct sunlight,
vibration and mechanical pressure.
• Never operate the product near gas or electric heaters, open fires, candles
or other sources of heat.
• Only place on a solid, non-slipping and fireproof surface.
• Do not cover the product.
1.2 Battery hazards
The batteries (rechargeable) are not replaceable.
•
Batteries may be damaged and leak if not used for the intended purpose.
• Leave leaked, deformed or corroded batteries inside the product and dis-
pose it by appropriate protectives.
• Do not short-circuit the battery or immerse it in liquids.
There is a danger of: Explosion, fire, heat, smoke and/or gas.
• Do not expose the battery to heat, such as sunlight or heat from heating,
or fire.
Extreme heat can lead to explosion and/or leakage of corrosive liquid.
Mechanical damage can cause gaseous substances to escape, which can be
highly irritating, flammable or toxic.

2 Description and Function

LED light as decorative light for living room, balcony, terrace or camping.
• after switching on it can be turned on and off by blowing
• three-level dimming with memory function
• with battery charge indicator
2.2 Scope of delivery
LED light Blowing Control with integrated Li-Ion battery, micro USB charging cable,
user manual
2.3 Operating elements and product parts
Fig. 3: Operating elements and product parts
1 LED lantern
3 Micro USB input
5 Dimmer button
2.4 Specifications
Rated voltage (V )
Rated current (A)
Number of LEDs (pcs.)
Power (W)
Corresponds to light bulb (W)
Nominal luminous flux (lm)
Energy efficiency class
Light colour
Colour temperature (K)
Colour rendering index (Ra)
Nominal life time
Dimmable
Housing colour
Housing material
Protection level
REV2018-08-27
V1.0
2 Battery charge indicator
4 ON/OFF switch
6 Micro USB charging cable
5.0
0.34
1
1.7
2.0
8
B
warm white
3000
80
20000

white
ABS
IP 20
Dimensions (Ø x h) [mm]
Weight (g)
Rechargeable Battery
Specifications
Quantity (pcs.)
Charging time (h)
Operation time (h)
Tab. 2: Specifications
3 Intended Use
We do not permit using the device in other ways like described in
chapter "Description and Function" or "Safety Instructions". Use the
product only in dry interior rooms. Not attending to these regulations and
safety instructions might cause fatal accidents, injuries, and damages to
persons and property.
4 Charging
NOTICE! Material damage due to incorrect power supply.
• Compare the specifications of product, power supply and peripherals.
These must be identical.
The battery must be fully charged before initial operation.
1. Connect the Micro USB input (3) of the LED light via the supplied Micro
USB charging cable (6) to an USB port.
This can be a 230 V USB travel charger, a 12/24 V car charger or an USB port of
your PC.
2. Slide the ON/OFF switch (4) to the „ON" position.
Fig. 4: Charging status
The charging indicator (2) starts flashing. The LED light is fully charged when all
4 LEDs of the charge indicator are permanently lit.
3. After charging, disconnect the Micro USB charging cable from the LED wind
light and the USB port of charging device.
4. Slide the ON/OFF switch to the „OFF" position.
Recharge LED light at the latest if the loading capacity is 25%.
5 Switching ON and OFF
1. Switching ON : Slide the ON/OFF switch (4) on the LED light to the
„ON" position.
2. Blow strong into the LED light.
3. Switching OFF: Blow out the LED light and/or
4. slide the ON/OFF switch to the „OFF" position.
6 Dimmer
The dimmer is adjustable in 3 steps.
1. Press the dimmer button (5) 1x = change from step 1 to step 2.
2. Press again = step 3.
When the dimmer button is pressed again, the LED light changes back to level 1
= max. luminous intensity.
Memory function: The last brightness level set will be saved. After switching off
and on again, the LED lights up again with the previously stored brightness level.
7 Maintenance, Care, Storage and Transport
The products are maintenance-free.
NOTICE! Material damage
• Only use a dry and soft cloth for cleaning.
• Do not use detergents or chemicals.
• When not using for longer time, charge every 3 months to keep the capacity.
• Store cool and dry.
• Store the product out the reach of children and in a dry and dust-protec-
ted ambience when not in use.
• Keep and use the original packaging for transport.

8 Disposal Instructions

8.1 Product
According to the European WEEE directive, electrical and electronic
equipment must not be disposed with consumers waste. Its components
must be recycled or disposed apart from each other. Otherwise contami-
native and hazardous substances can damage the health and pollute the
environment.
As a consumer, you are committed by law to dispose electrical and elect-
ronic devices to the producer, the dealer, or public collecting points at the
end of the devices lifetime for free. Particulars are regulated in national
right. The symbol on the product, in the user manual, or at the packaging
alludes to these terms. With this kind of waste separation, application,
and waste disposal of used devices you achieve an important share to
environmental protection.
WEEE No: 82898622
8.2 Battery
(Rechargeable) batteries must not be disposed of with household waste.
Their components have to be supplied separately to the recycling or dispo-
sal, because toxic and dangerous ingredients can harm the environment if
not disposed of sustainably. As a consumer, you are obliged to return them
at the end of their service lives to the manufacturer, the sales outlet or
established for this purpose, public collection points for free. Details regula-
tes the respective country's law. The symbol on the product, the instruction
manual and/or the packaging draws attention to those provisions. With this
kind of material separation, recovery and disposal of waste (rechargeable)
batteries you make an important contribution to protecting our environment.
D-34000-1998-0099
- 2 -
55497
90 x 99
130
Li-ion, 3.7 V | 1.85 W | 500 mAh
1
2
~
up to 7
Goobay
by Wentronic GmbH | Pillmannstraße 12
38112 Braunschweig | Germany
®