Trust PREMIUM-LINE ZCC-3500 Bedienungsanleitung Seite 5

5. OPTIONAL: ALSO CONNECT WITH ZYCT-202 REMOTE CONTROL
To use the switch with the ZYCT-202 and the App follow below steps.
A
Make sure the ZCC-3500 is paired with the App. (See chapter 4).
B
Connect the ZYCT-202 with the App. (Follow the instructions in the App to pair the ZYCT-202).
C Connect the ZYCT-202 with the ZCC-3500 by selecting a channel and holding the ZYCT-202 against
(or as close as possible to) the switch.
D
Then press and hold the ZYCT-202 ON button until the switch switches ON-OFF-ON-OFF-ON (clicks
5x).
To operate the ZCC-3500 only with the ZYCT-202, follow steps
sure the switch is not in connection mode (LED flashes slowly). Stop the connection mode by briefly
pressing the button on the housing. The LED on the switch stops flashing. After this follow steps
D
and from chapter 5.
6. MANUAL ON-OFF SWITCHING
With the ZCC-3500 you can also manually switch your lighting / device ON or OFF by pressing the
button on the housing.
ACTIVATE CONNECTION MODE FOR ZIGBEE CONTROL STATION (LIKE ICS-2000/SMART BRIDGE / Z1)
If the switch is not connected to a control station, you can activate the connection mode by shortly
pressing the button on the housing of the switch. The LED flashes slowly to indicate that it is in
connection mode.
RESET SWITCH
: With this step, the switch is removed from the control station and/or the ZYCT-202. To
Warning
reset the switch, press the button for 6 seconds. The LED will flash quickly. Press the button again
briefly. The socket switches ON and OFF 2x to confirm it is reset and then activates the connection
mode.
The wireless range increases if you add more zigbee products (meshing). Go to trust.com/zigbee for
more information about meshing.
ZCC-3500 WIRELESS SOCKET SWITCH
C and D from chapter 5. Note: Make
EN
C
5