Werbung
Instructions
1. Always refer to the manufacturer's documentation before commencing the job.
2. Refer to Figure 1: Remove four (4) anti roll bar (sway bar) mounting bolts (A) and one
anti roll bar drop link (can be from strut end). Figure 1 shows LH side. Anti roll bar (B)
can now be pushed up to gain clearance above the subframe.
A
Fig. 1
3. Refer to Figure 2: Remove the steady support bracket mounting bolts (C) and the
steady bar (dog bone) mounting bolt (D), then withdraw and remove the steady bar.
C
Fig. 2
4
B
D
4. Refer to Figure 3: Place the aperture plug mounting bar (B7) into position with the plug
(B8) itting into the aperture in the subframe. Secure with the provided set screws (B11).
If there is dificulty in lining up the holes in the subframe to insert the set screws, loosen
the plug (B8) securing screws to allow movement of the B7 assembly, then retighten.
5. Fit the Adjustment Bracket (B9), hooking over the back of the subframe. Ensure the
end of the adjusting screw (E) is located in the shallow slot on the bar (B7). Tighten the
adjusting screw (E) just enough to hold the assembly in tension.
B11
Fig. 3
6. The bush (F in Figure 3) can now be extracted. Lubricate the force screw (B15) with
molybdenum disulphide grease, then assemble the puller as shown in Figure 4.
Holding the anti roll bar up 0to gain clearance, place the bush collar (B4) up over the
subframe and onto the bush; secure onto the force screw (B15) with the top nut (B12).
Extraction
B7
B3
B2
B15
Fig. 4
E
F
B12
B9
B4
5
Werbung
