Cleaning And Maintenance - Constructor Ctrsc710Bc Übersetzung Der Originalanleitung

DESCRIPTION
1. On/off switch
2. Lock button
3. Lock for speed
4. Saw blade
5. Sole
6. Blade holder
8. Sole adjustment lever
9. LED work light
ASSEMBLY
Always check that the power supply corresponds to
the voltage indicated on the plate signage.
To prevent accidental starting, check that the lock
button is not engaged before plugging in the tool
and that you do not touch the ON/OFF switch with
your finger.
Changing the saw blade (B2)
▪ Always turn off and unplug the reciprocating saw
before working on the machine or changing the saw
blade.
▪ Turn the blade holder ring (6) as shown in Fig. 2
until the blade slips into the slot of the blade holder
(6).
▪ When you release the ring again, the ring should
return to its starting position.
▪ If this does not happen, try turning the ring by hand
to its starting position.
▪ Pull on the blade to check if it is seated properly in
the holder.
Sole adjustment (B2)
▪ Loosen the lever (8), pull or push the soleplate to
the desired position.
▪ Push the lever (8) backwards.
▪ Check that the soleplate is firmly attached.
Electronic speed control (B3)
▪ By increasing the pressure on the on/off switch (1),
the speed increases.
▪ With the speed selection (3) in the ON / OFF
switch (1), the desired speed can be selected.
Turn towards +: higher speed
Turn towards -: lower speed
Before plugging in power
cord, always pull on the
blade (8) to make sure it
is securely locked in the
clamp. Failure to do so may
OPERATION
On/off switch (B3)
To light up:
Press the on/off switch (1)
Switch off:
Release the on/off switch (1)
result in serious
injury.
Lock button (B3)
You can lock the ON/OFF switch (1) using the lock
button (2) when the equipment is running. To lock it,
press the ON/OFF switch.
To turn off the equipment, briefly press and hold the
ON/OFF switch.
Use as a jigsaw (B5)
Place the reciprocating saw on the material to be
cut as shown in Fig. 5. Turn on the reciprocating
saw and push it against the material to be cut.
Match your cutting speed to the material.
LED lamp
The LED light (9) helps to illuminate the work in
unfavorable lighting conditions. LED light (9)
turns on automatically as soon as you insert the
plug into the socket.
Power cable replacement
If the power cable of this equipment is damaged, it
must be replaced by the manufacturer or its after-
sales service.
after-sales service or personnel with similar training
to avoid any danger.

CLEANING AND MAINTENANCE

performing any work on
the equipment, pull the
Service
§ Only qualified specialist personnel and original
replacement parts should be used for repairs. This
will ensure that your device remains safe.
Cleaning
§ Regularly clean the machine housing with a soft
cloth, preferably after each use. Keep the
ventilation slots free from dust and dirt. If the dirt
does not come off use a soft cloth
moistened with soapy water. Never use solvents
such as petrol, alcohol, ammonia water,
etc. These solvents may damage the plastic parts.
Lubrication
The machine requires no additional lubrication.
Checking and replacing the carbon brushes
The carbon brushes must be checked on a regular
basis.
_ Remove the carbon brush holders and clean the
carbon brushes.
_ In case of wear, replace both carbon brushes at the
same time.
_ Mount the carbon brush holders.
_ After mounting new carbon brushes, let
the machine run at no load for 15 minutes.
Use only the correct type of
Attention! Before
power plug.
carbon brushes.
17