Installation Of The Quick Release Holder For; Holder; Latch Base - Thrustmaster Ferrari 488 GT3 Wheel Add-On Benutzerhandbuch

4. Installation of the quick release

holder

Ferrari 488 GT3 Wheel Add-On comes with two quick
release holders corresponding to the Thrustmaster base
formats.
System
Quick release holder for

latch base

Quick release holder for
screw base
Before each use, verify that Ferrari 488 GT3 Wheel
Add-On is still properly attached to the support, as per
the manual's instructions for the base.
Compatibility
T818, T818 Ferrari SF1000
Simulator
Thrustmaster bases.
T-GT / T-GT II Servo Base,
T300 RS Servo Base, TS
PC Racer,
Racing Wheel Servo Base,
TS-XW Servo Base.
13
and future
TS-XW, TX