knapp WALCO V 60 Montageanleitung Seite 7

Collar bold holding screw
Art. - No. K108
1. Drilling
40
2. Screwing countersink screw into Collar bolt
SK 8x80
Tip:
If the collar bold holding screw requires a higher
height, one additional washer can be laid under under the
collar screw washer.
The full thread screw can be pre drilled with a ∅ 5 mm
diameter.
Page 3/4
WALCO® V 60 VK D12
Positionierbohrung
Tiefe/depth
50 mm
40
VK D12
TORX 40
Construction Manual
WALCO V 60
1. Machined edge
Minimum milled dimension
30
60
Depth: 13 mm without joint => tight fitting
11 mm easy to connect (2 mm gap)
2. Marking Connector position with scribing jig
3. Assemble connector
Wall connector
depth
Art. No. K578
TORX 30
3 Hex-head-wood
screws 6x50 mm