Nomestic Airsight CO2 monitor Gebrauchsanweisung Seite 6

Overview and display
Battery level
Buzzer alert
Air quality indicator
CO2 level
Temperature/Humidity
Back
USB-C port
(left side)
10 Getting started
First use
Upon first use, the device will perform an automatic
calibration, lasting approximately 24 hours. The purpose
of the calibration is to determine the correct baseline
(zero measurement) reading and to ensure an accurate
Front
measurement.
1. Connect the CO2 meter to an adapter during the
2. Preferably place the device in a well-ventilated area.
Mounting hole
3. The device will reach an optimal measurement level
Ventilation system
calibration. This is important to prevent the device from
shutting down during the calibration.
This can be a room with an open door or a place by
the window. Make sure to limit the people and animals
present in room.
after the first 24 hours. You can then disconnect it and
move the device as desired.
Automatic calibration
The Airsight CO2 monitor has automatic calibration
functionality, allowing it to automatically adapt to a
new environment. You can therefore move and place
required.
Warning: Make sure the room in which the device is
located gets occasionally ventilated. This promotes air
quality as well as improving the CO2 measurement sensor.
Recommendation: you can keep the device connected to
an adaptor during usage. This can be useful if the CO2
meter has a permanent place, to prevent the battery from
running down.
Display and battery status
Charged Charging Low
11