Herunterladen Diese Seite drucken

Elebia e5 Gebrauchsanweisung Seite 9

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 24
FCC and IC
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmit-
ter, except in accordance with FCC multi-transmitter product procedures.
Any changes or modifications not expressly approved by the grantee of this device could void the user's
authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures: Reorient or relocate the receiving antenna; Increase the separation between the equipment and receiver.
Remote control
Mode button
'0 to 9' – autohook battery level
'C' - Check / maintenance
' . ' ring in position
(only units with magnet sensor)
´A´- Remote's battery is low
elebia® button
Power supply
Available Code Combinations
Detection of Errors in Transmission
Buttons
Frequency selection
Frequencies
Communication
Certification standards
Radiated power
Antenna
Range
Consumption at rest/transmission operation
Working temperature
Dimensions
Disclaimer: This brochure is for information only. The manufacturer reserves the right to modify specifications.
1 3V lithium battery (CR2032)
65,536 different combinations
2 CRC bytes + Forward Error Correction
2
1
865.95 MHz / 869.85 MHz
Bi-directional return of receiver battery status
EN 300 220 Telecommunications
EN 301 489 Electromagnetic Compatibility
EN 60730 Low Voltage
under 5 dBm
Printed circuit
100 metres / 330 Feet
5 uA/ 20 mA
-20 to +85ºC / -4 to 185 ºF
Minitel box (68 x 52 x 17 mm / 2,68 x 2,05 x 0,67 inches)
9
EN

Werbung

loading

Diese Anleitung auch für:

E10E20