Joerns Hoyer Presence Benutzerhandbuch Seite 23

Verfügbare Sprachen

English

*THESE CHECKS SHOULD INCLUDE:

= Recommended

1. SPREADER BAR: Check the spreader bar for freedom of rotation and

swing. Check for wear on the central pivot. Check for firm attachment to the

boom.

2. BOOM: Check the attachment of the boom to the mast. Make sure there is

only minimal side movement of the boom and the boom is free to rotate on

the boom bearing.

3. MAST: Check the operation of the mast-locking device. Make sure the mast

fully engages into the socket. Check the bottom actuator.

4. ACTUATOR: The actuator should require no maintenance other than

checking for correct operation and listening for unusual noise.

5. CONTROL BOX/SMART MONITOR: Check the function of the emergency

stop button. Inspect the hand control socket for correct fitting. Check functioning

of the hand control. Check the redundant controls and confirm they operate as

intended.

6. BATTERIES: The batteries are housed in the power pack and should not

require maintenance other than the regular charging as detailed in the

charging instructions. Check that the connections remain clean.

7. LEG ADJUSTMENT: Check the legs operate in both full extensions (inward/

outward).

8. CASTORS: Check all castors for firm attachment to the legs. Check for free

rotation of the castor and the wheels.

9. CLEANING: Clean with ordinary soap and water and/or any hard surface

disinfectant. Harsh chemical cleaners or abrasives should be avoided as

these may damage the surface finish of the lift. Avoid wetting any of the

electrical parts.

10. BASE AND WHEELS: Ensure base is even and level (all four wheels are

on the floor).

11. SLINGS: Check for wear and fraying.

12. LUBRICATION: Lubricate pivot joints with a silicone based oil, including mast

and boom connections, pedal assembly, spreader bar joint (only if required),

13. HAND SET: Ensure plugged fully into controller.

14. QUICK RELEASE PIN: Ensure the pin is securely fitted before lifting.

15. HARDWARE: Check all nuts, bolts, screws and fasteners for excessive

wear and for tightness. Replace as required.

Hoyer

Presence