Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Quicklinks
Instruction for the use of
the LED POWER SUPPLY
Model: SLT20-12VF-2S,SLT20-24VF-2S
Applications
This type of power supply is an exclusively designed stabilized
power supply for LED lamp, it is a switch mode power supplier
with 12VDC(SLT20-12VF-2S)/24VDC(SLT20-24VF-2S) constant
output voltage.
The built-in protection circuit will shut down the power supply in
case of such faults as: open circuit, short circuit , over load. The
power supply will restart automatically after fault correction.
Important information for the installation
The unit uses dangerous mains voltage(220~240VAC), it should
·
only be installed by qualified electricians according to European
safety standards or relevant nation regulations.
Failure to observe any of the installation instructions may cause
fire or other hazards.
The power supply is for LED lamps only, Pay attention to the
·
polarity of LED, wrong polarity may damage the LED.
The power supply is only for indoor use and permissible
·
operating temperature is -20 to 45℃.
With terminal cover and cable clamp, the power supply can be
·
independent installed.
The indicated load should not be exceeded.
·
The maximum length of the output cable to the LED lamps
·
should not exceed 2m in order to meet the EMC standard.
If the LED power supply is used for purposes other than
·
originally intended or it is connected incorrectly, the manufacturer
is not responsible for possible damages.
Wasted PCB during transit, delivery, use and scrap disposal can
·
cause certain environment damage. Please handle it according to
"waste electronic products disposal rules" locally
Manufacturer
SELF Electronics Co.,Ltd.
No. 1345 JuXian Road, Ningbo Hi Tech Park,
Ningbo, China 315103
Specifications
Input voltage :
220~240VAC
Input frequency :
50/60Hz
Input current :
0.13A
Input power :
24W
Input power factor :
0.85C
Constant output voltage : 12VDC SLT20-12VF-2S
24VDC SLT20-24VF-2S
Rated output power :
0~20 W
Ambient temperature :
-20-45℃
Case temperature :
90℃ SLT20-12VF-2S
90℃ SLT20-24VF-2S
IP protecton :
Primary cable :
H03VVH2-F 2X0.75mm
Secondary cable :
H03VVH2-F 2X0.75mm
IP20
2
2
Werbung
Verwandte Anleitungen für SELF Electronics SLT20-12VF-2S
Inhaltszusammenfassung für SELF Electronics SLT20-12VF-2S
- Seite 1 Input power : polarity of LED, wrong polarity may damage the LED. Input power factor : 0.85C Constant output voltage : 12VDC SLT20-12VF-2S The power supply is only for indoor use and permissible · 24VDC SLT20-24VF-2S operating temperature is -20 to 45℃.
- Seite 2 NETZTEIL Die maximale Länge des Sekundärkabels zur LED-Leuchte ꞏ sollte 2 m nicht überschreiten, um die EMV-Standards zu erfüllen. Modell: SLT20-12VF-2S,SLT20-24VF-2S Wenn das LED Netzteil für andere als die ursprünglich ꞏ vorgesehenen Zweck verwendet wird oder falsch angeschlossen Anwendung ist, übernimmt der Hersteller keine Verantwortung für mögliche Schäden.