FLYLINKTECH CF400 Bedienungsanleitung Seite 10

Step 3-a:
Connect the red clamp onto the positive pole of the car battery, then connect the black clamp onto the negative pole of
the car battery. PLEASE DO NOT reverse it. The green light stays on and buzzer beeps every 3s, you are safe to move
to next step.
Step 3-b:
If the red light stays on and buzzer keeps beep:
1)You may connect in reverse. you need to disconnect the battery.
2)Make sure the clamps are plugged into the jump starter completely.
Step 4:
Press the start button of your car to start the car in 30s.
1)To reduce the load of the car jump starter, turn off the vehicle's headlights, air conditioners and other electrical
components.
2)If fail to start the car, wait at least 1 minute and then start the starter again. If fail to start the car 3 times.you need
to use force button(please read the below instruction)
EN
8