Sun Garden Easy Sun LIGHT Bedienungsanleitung Seite 16

I
NSTALLING THE LIGHTING SET
3.2 Adapter
The adapter is fixed to the sunshade to allow
fixing of the lighting set fitting
3.3 Fitting
The fitting is designed to house the lightbulb and
the cover.It is provided with a bayonet connection
which allows rapid installation and removal. The
power supply plug and the cable entry hole into
the fitting are protected against water splashes.
The power supply cable is five metres long.
3.4 Cover
The lighting set cover is cone-shaped. It is
made of shockproof plastic and is therefore
resistant to knocks and scratches.
4.0 Installing the lighting set
Caution: Risk of trapping!
There is a high risk of trapping at all sunshade frame joints.
• Observe these risk areas and other hazards
Accident hazard through electric shock!
Several components in the lighting set fitting are live during operation.
• When installing, always ensure that the lighting set is disconnected
from the power supply.
• Take suitable precautions to ensure that the power supply is not
reconnected during installation by other persons unnoticed.
4.1 Tools required
❏
drill
❏
metal drill bit; ø 3.5 mm
❏
screwdriver; blade width 3.5 mm
❏
Phillips head screwdriver No. 2
❏
marking pencil
4.2 Preparation
➭
Open the sunshade completely.
➭
Remove the cable seat cover on the lower
spoke stand centrepiece with a screwdriver.
Page 4
Bayonet connection
Cable entry hole
Power supply plug
Centerpiece
with cable seat
Cover
Issue: 09.2002