Werbung
Verfügbare Sprachen
Verfügbare Sprachen
direction roughly every minute. The
red light is switched on.
5. The massage can be adapted with the
other three buttons:
○ set just one direction of rotation
or change it with the direction
button (1)
○ switch the red light / heat on / off
with the heat button (4)
○ change the rotational speed of the
massage balls to three levels with
the speed button (5)
6. The device switches off automati-
cally after 15 minutes. To switch it off
sooner, press the power button.
7. Disconnect the connecting cable
from the power source and the de-
vice.
CLEANING AND STORAGE
Please Note!
■ Do not use any corrosive or abrasive
cleaning agents to clean the device.
These may damage the surface.
y Wipe down the device and the foot
loops (7) with a damp cloth or
sponge and allow them to dry in the
air. Never place on a radiator or dry
with a hair dryer!
y Do not wind the mains cable around
the car adapter or mains adapter.
y Store the device and accessories in
a cool, dry place which is protected
from direct sunlight and dust.
y Store out of the reach of children and
animals.
TROUBLESHOOTING
If the device does not work properly,
check whether you are able to rectify the
problem yourself. If the problem cannot
be solved with the steps below, contact
the customer service department.
Do not attempt to repair an
electrical device yourself!
The device does not work or
switches itself off prematurely.
The device, car adapter or mains adapter
and power source are not connected
together correctly.
► Check and correct all plug connec-
tions.
The power source is not supplying any
power.
► Try another power source (plug
socket).
► In a vehicle: Turn the ignition key.
There is too much weight on the device.
► Reduce the weight on the device.
The device has been operating for too
long and has overheated.
► Disconnect the device from the pow-
er source and allow it to cool down.
Always disconnect the device from
the mains when it is not in use.
The device gets too warm.
The device has been operating for too
long and has overheated.
► Disconnect the device from the pow-
er source and allow it to cool down.
Always disconnect the device from
the mains when it is not in use.
The device makes noises.
Operating noises are a normal con-
sequence of the mechanics and not a
defect.
► If the noises increase, switch off the
device for approx. 30 minutes.
EN
19
Werbung
