Ground Zero HYDROGEN Serie Anleitung Seite 13

1 Speaker terminals
Power terminals
2
3 Status indication
4 RCA inputs
5 Input level controller
6 Bass boost controller
7 Bass boost frequency
8 Subsonic controller
9 RCA Outputs
10 Low pass controller
11 Phase shift controller
12 Remote control input
13 Slave In connection
14 Master Out connection
15 Master / Slave Switch
The amplifier automatically turns on a few seconds after you turn on your radio.
Note: Your amplifier temporarily shuts down if it gets too hot, then restarts automatically once it cools
(At about 80° / 176° F).
1. LEVEL (Min/Max): Turn fully counter- clockwise to MIN position
2. Turn the auto sound system's volume control to about two-third of its full range.
3. Adjust LEVEL to a comfortable listening level.
All manuals and user guides at all-guides.com
Controls and functions
For connection of the subwoofer
GND -> Ground connection
REM -> Remote antenna terminal
BATT -> +12 Volt
WHITE – OK
RED – Error
Terminal for connection of the RCA wires.
To avoid failure, please use high quality RCA wires.
With this controller you can adjust the input sensitivity.
For adjusting the bass boost level in the range of 0 to +9 dB.
For adjusting the bass boost frequency between 30 and 80 Hz.
This controller allows you to filter low frequencies in a range between 5 and 50 Hz.
This function reduces the mechanical Xmax and raises the capacity of the connected
subwoofer.
For connection of additional amplifiers in fullrange operation.
Adjust the variable lowpass frequency to the desired frequency between 30 and 250
Hz using the controller.
This controller allows you to fit the subwoofer channel in-phase to the front system.
For connection of the bass remote control.
For connection of the slave amplifier in link mode. See page 6
For connection of the master amplifier in link mode. See page 6
For choosing the operation mode of each amplifier in link mode. See page 6
Turning on the amplifier
Adjusting the audio level
- 5 -