Primo DV1-WS Gebrauchsanleitung Seite 56

DV1-WS / PR104DV / PR111DV / PR123DV / PR124DV / PR125DV
1. Thermostat
2. Freezer drawers
3. Adjustable feet
• Remove all packing material, both inside and outside.
• Clean the outside of the unit with a dry cloth. You can clean the inside with a
soft damp cloth.
• Do not place the appliance in a narrow passage, in direct sunlight or moisture.
• Make sure that air can circulate freely around the refrigerator. The back of the
refrigerator should be at least 5 cm away from the wall.
• Place the refrigerator on a solid, level surface. If your surface is not flat, you can
straighten the appliance using the feet. You can raise or lower these by turning
them.
• Avoid direct sunlight and heat. Sunlight can damage
the outside of the refrigerator. Heat will cause higher
consumption.
• Avoid excessive humidity. Too much moisture in the air
will cause frost to form too quickly in your refrigerator.
• The thermostat is located on the inside of the
appliance. When you open the door, you can set the
thermostat at the top. Set the thermostat to "MAX" for
maximum cooling. The higher the setting, the harder the appliance will cool.
PARTS
3
INSTALLATION
56
1
2
2
2
3