Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
Safety instructions
Pay attention to the fact that water temperatures in excess of approx. 43 °C are
perceived as hot, especially by children, and may cause a feeling of burning. Please
note that the fittings and taps may be very hot when the appliance has been in use
for some time.
The appliance must never be exposed to frost.
Installation
1. Screw the ½" connection of the tap to the water supply. Use an approbiate seal.
2. Connect the outlet pipe with the tap.
3. Connect the instantaneous water heater with the ⅜" connectors on the top of
the tap. Use the provided seals to tighten the connection. The instantaneous
water heater's manual must be observed.
4. Check all connections for leaks.
If you have any trouble with the installation, please contact the CLAGE Central Cus-
tomer Service.
Technical specifications
Maximum water temperature: 65 °C
Maximum water pressure: 1.0 MPa (10 bar)
Nominal water pressure: 0.1 to 0.5 MPa (1 to 5 bar)
Water supply
Wasserzulauf
4
To IWH cold water inlet
zu Kaltwasseranschluss Durchlauferhitzer
From IWH warm water outlet
von Warmwasseranschluss Durchlauferhitzer
Werbung
